Reorient or relocate the receiving antenna.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. This device must accept any interference received, including interference that may cause undesired operation.This device may not cause harmful interference.Operation is subject to the following two conditions: This device complies with part 15 of the FCC Rules. Check USB hub documentation for current/port specification. MV5 is plugged in, but the volume meter does not register a signal.Įdit the privacy setting for the iOS device under SETTINGS > PRIVACY > MICROPHONE to give the recording application permission to use the microphone. Make sure that the sample rate and bit depth microphone settings, found in the sound control panel of the computer, are consistent with the sample rate and bit depth selected in your software. If level is reaching the red peak indicator of the input meter, turn the gain down. Use the audio meter to ensure that volume peaks are within the target range. When first connecting the MV5 to your computer, make sure to raise the computer volume level.Ĭheck the sound control panel of the computer to ensure that the MV5 is fully plugged in and recognized. Make sure that the MV5 is fully plugged in.Ĭheck the computer sound control panel settings.
See your software user guide for information on assigning input sources. In your recording application, select the MV5 as the input source.Refer to the "Adjusting Microphone Level" topic in this guide for details.
However, the modes typically do not require additional gain adjustments. If the audio is too quiet or causes distortion, gain can be manually configured.